Pet Blowing Machine Must Ensure Good Mechanical Parts

1 Pet Bottle Preform mold must be cleaned and polished regularly.
2 Open the source under the pressure switch must be slow to prevent the air flow from blowing dust into the solenoid valve too quickly, and open the exhaust valve for 30 seconds to ensure the air is clean.
3 Plastic blow molding machines must ensure that the mechanical parts are good, there is no one inside the machine, no foreign objects. Especially the handle position to avoid injury. Also close the security door.
4 Start the machine must start the motor, delay the heating machine for 30 seconds to prevent voltage jitter. Before starting heating, you must ensure that the cooling water is not turned on.
5 15 minutes after the start of heating (2 – 3 minutes), when the temperature of the oven rises evenly, press the button in the embryo. At the same time, open the bottle’s power, or do not blow the bottle.
6 Plastic blow molding machines must pay close attention to whether the machine will run with the same noise to achieve early detection and stop early settlement in time.
7 In an emergency, press the emergency stop button and press the brake. Then find a quick solution to the problem based on an analysis of the cause of the site.
8 After normal operation, the body of any part of the machine should not be placed in the machine, so the robot will not hurt people. If the machine has an abnormal sound, you can slow down after watching.
9 After normal consumption, the operator should always observe the quality of the bottle to avoid shaking voltage or other reasons that affect the quality of the bottle.
10 During maintenance, press the service button to ensure the safety of the repair according to the defects on the touch screen. If you need to observe the movement of each mode by hand, please pay attention to the position of the robot. At the same time, it is important to understand the role of the button separately and then put it into action. Make sure the error is caused by unnecessary trouble.
11 After each pet blowing machine repair, you must ensure that tools and screws are cleaned to prevent the machine from remaining and affecting the normal operation of the machine.

Leave a Reply

Your email address will not be published. Required fields are marked *


*

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>