Once you have the above status on the different components

Now you can remove the IDE cable fully from the DVD drive. You have upgraded you Xbox HDD; replace the top. Remember to loosen the IDE cable without fully disconnecting it. Once you have fully cloned, exit and return to the main menu. Make sure to get good quality HDD for your Xbox. Using the y splitter or other method power both the Adds, the old HDD and the new HDD.

Once you have the above status on the different components, you are ready to proceed to the next step. After choosing the right option, you must confirm the locking feature. You will see the first menu once the Chimp launches. Now you should plug the cable to the new HDD. China Coaxial Connectors Suppliers You will not be able to boot your Xbox without the IDE cable. Go to the application s menu and launch Chimp through the dashboard. Using the tore screwdrivers open the Xbox and remove the top. Secondly, you would need a Molex y splitter. You can now switch off the Xbox, remove the master, which is the original HDD, and power the slave or the new HDD directly without the use of y splitter. You will find the locking feature available in the option number 3. This will be the status of various components: Original HDD power plus IDE, New HDD power plus IDE, DVD power but no IDE. The returning screen will look like you Dos prompt screen. If you do not have a y splitter, you just need to find a way to supply power to the old as well as your new HDD at the same time. Switch on the Xbox and allow it to boot into dashboard. You can choose option 2 if you know the eeprom backup in the tmp folder. Once the locking is complete, you can exit Chimp and return to Shell. Once you see both the HDDs listed, you can exit to complete this phase. The duration for cloning will vary from one system to the other depending on the data available. Now it is time to get the information from the master to the slave; you can do this by using clone master to slave feature. You must have chimp installed on your Xbox. The system will ask you for the source key.

You would need a few things to help you with the process. If you are not familiar with that location, you should choose option 1. You will be able to see both the HDDs in the results once they are detected.

In the finalizing steps, you need to lock the drive before leaving the Chimp.If you are wondering how to upgrade your Xbox HDD, here is an easy approach. While opening the top, you must unplug your Xbox from the power supply for safety reasons. Here you should select only slave. Once you click yes, you will see the system scanning for the available devices.
. You must check the Xbox HDD in advance before opening the Xbox. You must clone the entire disk. At the back, you will RG6 find a jumper where you will be able to find various options including slave, master and cable select. You must choose yes when you are asked to make sure that you are connected to all the IDE devices. Finally, you would need Torx screwdrivers of appropriate sizes to open the Xbox.

Leave a Reply

Your email address will not be published. Required fields are marked *


*

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>